Most likely painted/stained western red cedar; alternatives include cypress or treated softwood.
Thuja plicata (probable; uncertain from the image) · Softwood (conifer)
AI-generated identification · may be incorrect- Type
- Softwood (conifer)
- Origin
- Pacific Northwest of North America, especially coastal British Columbia, Washington, and Oregon.
- Hardness
- Approximately 350 lbf Janka; Very Soft.
- Durability
- Durable naturally, with good decay resistance when heartwood is present; generally resistant to insects, though exposed weathering eventually causes surface degradation.
Got a wood sample like this?
Identify any wood from a photo, free.
Grain Pattern
Mostly straight, fine, vertical grain with low visible figure; appears surfaced and coated, obscuring detail.
Color & Appearance
Underlying wood appears pale gray-tan, likely weathered or gray-stained; heartwood may originally have been pinkish to reddish brown, with subdued luster.
Hardness (Janka)
Approximately 350 lbf Janka; Very Soft.
Durability & Decay Resistance
Durable naturally, with good decay resistance when heartwood is present; generally resistant to insects, though exposed weathering eventually causes surface degradation.
Value & Age
About $3–$8 per board foot for clear western red cedar; painted architectural stock is usually valued by the component, not raw lumber grade.
AI estimate for general guidance only — not a professional appraisal. Actual value depends on grade, dimensions, condition, and local market demand.
- Wood Age Estimate
- Cannot be determined visually; the gray surface likely reflects weathering or finish rather than age, and the component may be relatively modern.
Common Uses
Exterior siding, trim, shingles, fencing, sheds, outdoor furniture, cabinetry, and light construction.
Geographic Origin
Pacific Northwest of North America, especially coastal British Columbia, Washington, and Oregon.
Workability
Very easy to cut, plane, sand, glue, and fasten, but its softness allows dents and crushed fibers; resin can affect tooling and finishing.
Finish Recommendations
Clean and lightly abrade, then use an exterior penetrating stain or quality acrylic coating; seal end grain carefully. Test adhesion because the existing coating is unknown.
Notable Features
Low density, stable movement, distinctive aromatic scent when freshly cut, and naturally decay-resistant heartwood.